SpaceClaim Online Help

Create a hole

1. Create a circle at the end of the bracket.

   1. Click Circle in the Sketch group and then click the top surface of the long arm of the bracket.

   2. Click Plan ViewOrientation settings that you can apply to your design, including spin, pan, and zoom. You can adjust these settings individually or you can apply one of the following preconfigured views: Trimetric, Isometric, Top, Bottom, Front, Back, Right, Left. You can also select Snap View and click a face to view it head-on.  in the Orient group to view the sketch grid head-on.

      You cursor will snap to the center of the arc created by the full round, and it is marked with a cross.

   3. Click the center of the arc and move the cursor to begin sketching a circle, then use the spacebar to dimension the diameter to 0.3".

       

      

       

2. PullTool used to distort or deform geometry. Use the Pull tool to offset, extrude, revolve, sweep, draft, and blend faces; or to round, chamfer, or extrude edges. When converting a sketch to 3D, pulling a line creates a surface and pulling a surface creates a solid. the circle to create a hole in the end of the bracket.

   1. Click the PullTool used to distort or deform geometry. Use the Pull tool to offset, extrude, revolve, sweep, draft, and blend faces; or to round, chamfer, or extrude edges. When converting a sketch to 3D, pulling a line creates a surface and pulling a surface creates a solid. tool in the Edit ribbon group and go to Home viewTool used to return the view to the Home settings. You can customize the Home view tool so that it displays your design with a specific orientation, location, and zoom level..

   2. Select the circular region and drag downward until all the material is removed.

      

       

   3. Drag with the middle mouse button to spin the bracket so you can see through the hole.

3. Save your work.