SpaceClaim Online Help

Modify the design from the drawing sheet

1. Change the design from the drawing.

   1. Change the size of the .3 diameter hole at the bottom of the bracket.

   2. Turn the drawing so you can see inside the hole by clicking the SpinTool used to re-orient your design in any direction, allowing you to view it from any angle. tool in the Orient ribbon group and dragging to spin your design.

   3. Click on the Design2D or 3D model that contains at least one top-level component. tab above the ribbon.

   4. Enlarge the view by selecting Zoom Box In from the Zoom menu in the Orient ribbon and drawing a box around the hole.

   5. Select the PullTool used to distort or deform geometry. Use the Pull tool to offset, extrude, revolve, sweep, draft, and blend faces; or to round, chamfer, or extrude edges. When converting a sketch to 3D, pulling a line creates a surface and pulling a surface creates a solid. tool in the Edit ribbon group then select the inside diameter of the hole. Press and release the spacebar and enter a radius of .2.

   6. Zoom out. The dimension has been changed to .4 on the drawing.

2. Two views of the changed drawing.

   1. To see the drawing view, right-click and select ViewOrientation settings that you can apply to your design, including spin, pan, and zoom. You can adjust these settings individually or you can apply one of the following preconfigured views: Trimetric, Isometric, Top, Bottom, Front, Back, Right, Left. You can also select Snap View and click a face to view it head-on. > Flat ViewOrientation settings that you can apply to your design, including spin, pan, and zoom. You can adjust these settings individually or you can apply one of the following preconfigured views: Trimetric, Isometric, Top, Bottom, Front, Back, Right, Left. You can also select Snap View and click a face to view it head-on..

   2. To view the whole drawing, right-click and select ViewOrientation settings that you can apply to your design, including spin, pan, and zoom. You can adjust these settings individually or you can apply one of the following preconfigured views: Trimetric, Isometric, Top, Bottom, Front, Back, Right, Left. You can also select Snap View and click a face to view it head-on. > Home.