Creating and changing edge reliefs

SpaceClaim Online Help

You are here: Working with sheet metal > Modifying sheet metal parts > Creating and changing edge reliefs

Edge reliefs

Edge Closed reliefs are automatically created when you pull a partial wall.

The edge relief type is determined by the Edge Relief option tool in the Modify group on the Sheet Metal tab. The default is round, but you can change it to another type. The icon on the Edge Relief tool changes to reflect the relief type. This setting is saved until you close SpaceClaim.

The shape of the end of a partial split is also determined by the relief type you have set for the Edge Relief tool. See Splitting a sheet metal face.

The dimensions of a relief are determined by the relief settings in Sheet metal options.

Dragging a yellow ball end point to pull a partial wall creates an edge relief.

A message appears in the status bar if a relief cannot be created, such as when it is too close to the side.

After you create a bend that has an edge relief, you can select the relief and change the type using the Edge Relief tool, or you can change the type, depth, and width in the Properties panel Closed . You can also move an edge relief along a sheet metal wall.

Edge relief type	Icon
Round
Square
Rip
Circular
Smooth

Smooth and Circular edge reliefs do not change the 3D geometry. Their effect is seen in the unfolded part.

To change an edge relief type and dimensions

Select an edge or face of a relief.

You can Ctrl+click to select multiple reliefs.
Select an option from the Edge Relief tool in the Modify ribbon group on the Sheet Metal tab.

You can also select a relief type from the mini-toolbar or modify the Bend Relief Type in the Sheet Metal section in the Properties panel. Depending on the relief type, you can also modify:
- Bend Relief Width: The width of the relief is A in the images below.
- Bend Relief Depth: The depth of the relief is B in the images below.