Midsurface Options
The following options are available in the Options panel:
| Use selected faces | Creates midsurfaces for only the faces you select. |
| Use range | Creates midsurfaces on all faces in the specified thickness range. |
| Thickness tolerance | Change the value of this option to detect offset spline faces with an offset value within the tolerance amount. |
| Create midsurfaces in | Select Same component to create the midsurfaces in the same component as the part you selected for midsurfacing. Select Active component to create the midsurfaces in the active component. |
| Create midsurfaces at | Select the location for the midsurface created. Choose from Middle (default), Bottom (green), or Top (cyan). |
| Group midsurfaces | Select this option to create midsurfaces in a new sub-component. Deselect the option to create the midsurface objects in the component you select in the option above (same component or active component). |
| Extend surfaces | Select this option to extend surfaces to another surface. |
| Trim surfaces | Select this option to trim surfaces to another surface. |