Shrinkwrap Tool Options
The following options are available for shrinkwrapping:
| Size | Enter a value for the average facet size that will be used for shrinkwrapping. Distances under this size may be walked over, while distances above this size will be considered acceptable and will not be closed. |
| Keep original bodies | When enabled, the original faceted bodies will not be removed after the Shrinkwrap is created. |
| Preserve features | When enabled, this keeps hard edges and doesn't smooth them. Set the Angle threshold which decides which edges to keep. |
| Angle threshold | Enter an angle, in degrees, that determines the smoothness of the shrinkwrap. Facet angles above the threshold will not be smoothed by the shrinkwrap. |
| Secondary size | Specify a facet size (smaller than the Size) to apply to selected facets. This allows you to refine the shrinkwrap locally. |
| Max size | Enable this option to make the triangles conform more to the shape with different sized triangles based on curvature. Specify the maximum triangle size for curvature dependent faceting. |
| Curvature angle | Specify the curvature angle for curvature dependent faceting. The curvature angle sets the facet-to-facet angle limit for the facets to conform to the curvature. |
The Zoom Legend appears at the lower-right of the screen. If the zoom legend is on before entering this tool or is turned on while using this tool, it will remain on when exiting the tool.